Acrylic Display Case Clear Action Figure Display Case with Mirrored Back, Dustproof Protection Display Box Alternative Glass Case for Collectibles Figures Models Doll Toys (6x6x10 inch; 15x15x25 cm)

Súper elegante para mostrar lo que se desea

I had some difficulty putting it together, even with the instructions, but it was worth it and will make the perfect display for my Bigfoot toe.

assembly is a challenge

Very nice display case for the price. Assembly went smoothly. The major drawback is that the protective film on the panels was very difficult to remove. Would be a major improvement if manufacturer left a small pull-tab on each piece of film. With that, I would have rated 5 stars.

These are really nice will defenatly getting more, it was pretty easy to set up, and the feel really rigidge for the price point.

I ordered a smaller version of this case for a bobblehead. It was a pain to put together, but I finally got it. It was slightly too small for the bobblehead, so I used the smaller case for something different and bought the next larger size. I figured I'd have an easier time putting together the second one. WRONG!! Once I had the time to sit down and put the larger case together (after the return window, of course 🙄), I realized that not one of the screws is long enough to secure the corner clips to the base or side pieces. Since I can't send it back, now I have to take the time to use some kind of adhesive along with the too-short screws. A project that should've taken 10 minutes has turned into a major ordeal. All of this could've been avoided if quality control had tested the length of the stupid screws!!

I bought this to keep dust off an anime figure. For that, it does a so-so job. Since the sides have some noticeable gaps, they let dust in pretty easily. However, the mirrored back lets me see a full 360 view of the figure, and that adds enough to the piece's display that it's worth it. Plus, this was one of the few display cases available that actually fit my figure's dimensions.Assembly was pretty simple- the pieces more or less slot into each other. Two tips for putting this together: (1) WEAR GLOVES WHEN YOU HANDLE THIS. Every plane of this thing shows fingerprints like crazy, and you'll go nuts trying to get them off. The inside is NOT easy to clean, once its together. The kit comes with at least 1 soft, fabric glove, but I'd cover both hands if I did this again. And (2) Make sure you peel the protective film off BEFORE you put the pieces together. The film gets stuck between the grooves if you don't.

Assembly required, wasn’t too hard and they give you extra hardware and white gloves for handling, maybe 10-15 min.Mirrored back looks great!