REES52 GY-521 Mpu6050 Module+ 3 Accelerometer for Arduino

I used this Sensor which works perfectly and shown given accuracte results. At first I feared whether online purchased components works or not, but I really happy that thi product is good. And REES52 was a trustable seller.

I have been using this for about a month and this product works as expected. Its good for what i paid (250 rs in my case) but you can find it for cheaper in local market(-1 star for price).Works fine with my arduino uno, and i expect this to perform similarly on other development boards.I expected this to be bigger looking at the pictures but iys actually quite small.Also, you get header pins with this so you can directly solder if you want to.Go for it if you're a student and are looking for an accelerometer for making self balancing robot and other stuff.

Well i am using this for making a Quadcopter with ardiuno+mpu6050 using multiwii.I got the same module from local shop which was a shit..It really didn't work wasted my money on that. It's sensor or microchip got brust i guess.But this is working just as expected it to. I had a problem with I2C error which is really a basic error with your hardware.I had a problem and my I2C errors were jumping from -32k to +32k. But after shouldering it well. It is working just fine...This time my money didn't got waste.I will give 4/5, why?as per my opinion they should provide it with pins sholdered i guess! Well it's because i didn't used it for anything else then this project? Idk... if they aren't there could be a reason but it was really helpful if it comes with sholdered pins.Afternoon thanks for this one!

Ok

Working good.. Bt compare other websites little Costly .

Writing this review after months of usage.First off, the pins aren't soldered so be sure you know what you're purchasing. This is not a breadboard-friendly sensor unless you can solder the pin heads to the sensor yourself.The sensor works like a charm with proper response time and orientation.Tested with Arduino Mega, Arduino Nano, Arduino Uno & Raspberry Pi 3

The product was defective, the packaging was not good either. I used the Arduino Accelerometer program to check whether it is working or not. Turns out its address bus is damaged and its showing all zeros even after initializer command!

The connections are a bit lose, if the device is fixed rigidly, like on a piece of wood. It works.Just follow tutorials on YouTube if you don't how to do the setup.