Instructions:1. Before the hot back to keep clean, according to the use of iron to adjust the temperature to fit the temperature of clothing.2.Put the cloth into the appropriate location, hot melt adhesive side of the clothes (glue do not tear), preheat the iron, from the cloth paste the front ironing about 15 seconds, this is to play a fixed patch position Can also be used before the ironing line with a fixed position to prevent cloth paste offset. And then fixed the location of the cloth together with the clothes in turn,from the opposite ironing 30-60 seconds to ensure that the back to melt, and then from the front ironing 1-2 minutes, the corner to force more than two to ensure that the surface level Smooth, combined with clothes.3. In order to prevent the heat, you can put a layer of thin cotton cloth on the cloth (must be cotton yo, can not fade cloth). Hot check after the edge to see whether the hot, hot on the edge of a few times. 4. also root decals to determine the thickness of the temperature, thicker, must be higher temperature, hot time longer. For thick cloth paste, you can burn a few times on the back.5.Note: For a cloth with a sequined or relatively bright surface (due to the sequins are plastic products) must pad a layer of cloth and with low temperature ironing (150 ℃ below), or directly with a steam iron. Or pad a layer of wet cloth on top of it. So as to avoid high temperature caused by plastic sheet melting.6. A good way is after the ironing is good, with the needle and thread in the cloth on the edge of a few stitches, so more solid, but also very obedient.7. There is no iron at home, you can also use the same color line will be posted on the clothes cloth.
Trustpilot
4 days ago
1 week ago
