AQUACREST In-Line Water Filter for Refrigerator and Ice Maker, 5 years or 10,000 Gallons High Capacity, 1/4-Inch Direct Connect Fittings, Reduces Chlorine, Bad Taste & Odor

There good 👍

I purchased this inline filter because our LG refrigerators ice had an awful odor. After installation, the ice was perfect! No more purchasing ice at the store.

Funciona por ahora cumple.

It comes with a bunch of fittings but I still had to buy some extra stuff for installing under the sink. I am not sure how one could order a replacement one without all these extras. The replacement after some years will definitely be plug and play though.

I have some trepidation over water leakage after reading other reviews but so far so good. It was relatively easy to install for an 81 year old guy with a bum leg but the wife complains of a plastic taste after 3 days. We hope the taste improves over the next week but to be honest, I'll purchase a different filter next time with threaded inlets due the complaints about water leakage.

Somewhat larger than expected. Maybe will last longer than expected. I hope so. But the one mounting bracket that came with the unit will not hold up this filter in a bouncing RV.

it will work

Past time to replace the original filter for my Icemaker rig. My apartment manager refused to run a dedicate water line to my refrigerator's icemaker, so I built this rig. Everything except the wood and the cutoff valve, I found on Amazon for under $150. The replacement came with additional fittings that I did not need. Total cost under $170.00 (Aug-Sept 2022.)My primary concern was the 1/4" inline connection fitting and how difficult the disconnect/reconnect would be (this is my first time changing the filter). The replacement came with additional fittings and a mounting clamp .I turned off the pump, closed the cutoff valve, disconnected the old filter (by pushing the line into the existing filter, holding down the resistance ring at the connection point, and removing the line -- at each end) and reconnected the new filter which was a simple matter of inserting the existing 1/4" line into the new filter -- no difficulty here. none of the additional provided fittings were needed Yes, I made sure of the "flow direction.The only two (very minor) issues I encountered 1) I should have had a towel as there was some minor "blow out" as I did not completely seat the out going waterline. 2) I needed to use the new filters mounting bracket (supplied with the filter).All in all, I'm very pleased with the product. Hopefully it will be available in 5 years when I'll need to replace it again.